Interfire Audio T-460, T-480, T-2100, T-1000M, T-270, T-2130 Installation Diagram

Page 5

INSTALLATION

MOUNTING:

1.After reading precaution, decide where you are going to install the unit. Also, see Fig.1.

2.Once the location has been determined, place the amplifier into position. Using a felt tip pen or pencil mark the four holes to be drilled for mounting. NEVER use the amplifier as a template for drilling. It is very easy to damage the amplifier surface in this manner.

3.Remove amplifier. Drill four 3.5 m/m holes into mounting surface. If you want to mount the amplifier to MDF or wood panel, drill four 3.0m/m diameter holes into mounting surface.

4.If possible, test the system to ensure it is operating correctly before final mounting of the amplifier.

5.Mount the amplifier using the supplied 4 self tapping screws.

INSTALLATION DIAGRAM

Self Tapping Screws

FIG.1

3

Image 5
Contents Mono Channel / 2 Channel / 4 Channel Automotive Amplifier Page Congratulations on your Purchase Page Installation Diagram InstallationInput Connections ConnectionsMono Channel System Wiring Diagram Channel System Wiring Diagram CH1 CH2 CH3 CH4 Speaker Connections Mono Channel Speaker Wiring DiagramCH Speaker Wiring Diagram Speaker + 1 Subwoofer Adjustments FRONT/REAR Panel 2CHANNEL Mono Channel FRONT/REAR Panel 4CHANNELTrouble Shooting Guide Specification 1000M 460 480 Warranty Santa Fe Springs Road Santa Fe Springs, CA 90670