Moen T555, T473 installation instructions Installation Instructions, Measurements, MT662C, Clip

MODELS 2600, 2700, 5401, 62600, 62700, 72615, 72700 and MODEL SERIES T471,	MT662C
T473, T555, T666, T777, T888, TL470, TL471, TL473, L2600, L2700

®

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE

LEFT WITH HOMEOWNER

TUB AND SHOWER VALVES

Available with three or four port castings, with and without stops.

Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections.

If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used.

Measurements

These are shown in the drawings. The depth measurement is critical.

Use the front face of the plaster ground as a reference point for the fin- ished wall position, including tile (2-1/16" [52mm]). The center line of the supply and discharge piping should be a maximum of 2-3/16" (56mm) and a minimum of 1-7/16" (37mm) behind the finished wall surface.

IMPORTANT: SEE FLUSHING INSTRUCTIONS PAGE 2

A

B

	TUB/SHOWER		FLANGE	FINISHED WALL
	COMBINATION			LINE
		SHOWERHEAD
			SHOWER
			ARM	2-1/16"
HANDLE	HANDLE
				(52mm)
COVER	KNOB	WASHER	PLASTER		6' 6"
			GROUND	1-1/4"
					(1981mm)
			ESCUTCHEON	(32mm)

HANDLE	HANDLE	SUPPLY
SCREW	LEVER

TUB FILLER OR SHOWER

2-1/16" (52mm)

SUPPLY

15/16"

C

	STOP TUBE
HANDLE LEVER HANDLE SCREW HEXAGONAL
	WRENCH
	WASHER
SET SCREW	STOP TUBE
HANDLE ADAPTER &		FLOOR
BRAKE ASSEMBLY

32"

(813mm)

CAUTION

USE 1/2"

IRON PIPE

SIZE

MINIMUM

OR 1/2"

TUBING.

(24mm)

45"

(1143mm)

48"

(1219mm)

Always turn water off before installing or disassembling the valve. Open

CAUTION: valve handle to relieve water pressure and to insure that complete water shut-off has been accomplished.

Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises could result.

CLIP

EAR