Moen T555, T471, T473 installation instructions Installation Instructions, Measurements, MT620J

MODELS 2290, 2291, 2600, 2700, 5401, 62600, 62700, 72615, 72700	MT620J
and MODEL SERIES T471, T473, T555, T666, T777 & T888

®®

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE

LEFT WITH HOMEOWNER

TUB AND SHOWER VALVES

Available with three or four port castings, with and without stops.

Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections.

If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used.

Measurements

These are shown in the drawings. The depth measurement is critical. Use the front face of the plaster ground as a reference point for the finished wall position, including tile (2-1/16" [52mm]). The center line of the supply and discharge piping should be a maximum of 2-3/16" (56mm) and a minimum of 1-7/16" (37mm) behind the finished wall surface.

IMPORTANT: SEE FLUSHING INSTRUCTIONS PAGE 2

TUB/SHOWER	FINISHED WALL	TUB FILLER
		OR SHOWER
COMBINATION	LINE

HANDLE	HANDLE		PLASTER
COVER	KNOB	WASHER	GROUND
HANDLE		HANDLE
SCREW		LEVER

2-1/16"
(52mm)
	6' 6"
1-1/4"	(1981mm)
(32mm)
SUPPLY

2-1/16" (52mm)

SUPPLY

15/16" (24mm)

	ESCUTCHEON
	ADJUSTABLE	32"
		(813mm)
	TEMPERATURE
UP	LIMIT STOP

HANDLE ASSEMBLY

CAUTION

USE 1/2"

IRON PIPE

SIZE

MINIMUM

FLOOROR 1/2"

TUBING.

45"

(1143mm)

48"

(1219mm)

Always turn water off before disassembling the valve. Open valve handle to

CAUTION: alleviate water pressure to insure that complete water shut-off has been accomplished.

Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises could result.

CLIP

EAR