Interfire Audio G4-600, G4-1000, G5-900, G2-800, G4-800, G2-1200, G2-600 instruction manual

Page 4

NEVER operate the amplifier without the proper power and ground wire, 10 gauge minimum.

NEVER operate the amplifier without proper fusing. Fuse holder must be located with in

0.5meters from the battery. This fuse is to protect the car not the electronics. In case of a short, the fuse will blow instead of the wire burning up. Using other than the recommended

fuse ratings at the battery and at the amplifier may cause damage to the amplifier and will void your warranty.

Do not run wiring underneath or outside the car since exposure to the elements may cause the insulation to deteriorate rapidly, resulting in short-circuits and/or intermittent operation. all cables should be run beneath carpets and inside trim pieces.

To help minimize interference, it is best to run the power cables along the opposite side

from the audio cables

.

Whenever wires pass through metal, rubber or plastic grommets must be used to prevent the metal from wearing through the installation and causing a short.

Whenever possible, use cable ties, mounting clamps and similar wiring aids. (available

from an electrical supply or auto parts store) Adding stress relief loops to wiring is also advisable to prevent straining or breakage.

• It is best to test the system before the amplifier is mounted and interior of car is reassembled.

If the temperature inside your car reaches extreme levels(such as sitting locked up for several hours in the hot sun or exposed to a very cold winter's day)the amplifier may go into protection mode and shut off. Leave the unit off until the ambient temperature returns to normal.

The amplifier operates with any vehicle using a 12 volt negative ground system. If you are not sure of the type of electrical system in your vehicle, consult your authorized dealer or qualified mechanic.

NEVER ground the speaker leads and NEVER allow the speaker leads to come in contact with each other. Speaker wire should be 18 gauge or larger.

Remote turn on wire must be switched by the radio does not have a remote turn on or antenna output, connect to wire that has a positive 12 volts when the key is turned to the accessory. If the amplifier does not turn off the battery will die.

Do not listen to high volumes for extended periods of time or hearing damage may occur.

CONTINOUS EXPOSURE TO SOUND PRESSURE LEVELS OVER 100dB MAY CAUSE PERMANENT HEARING LOSS. HIGH POWERED AUTOSOUND SYSTEM MAY PRODUCE SOUND PRESSURE LEVELS WELL OVER 130dB. USE COMMON SENSE AND PRACTICE SAFE SOUND.

2

Image 4
Contents G2-600 / G2-800 / G2-1200 G4-600 / G4-800 / G4-1000 G5-900 Page Congratulations on your Purchase Page Installation Installation DiagramConnections Input Connections2CHANNEL System Wiring Diagram 4CHANNEL System Wiring Diagram 5CHANNEL System Wiring Diagram CH Speaker Wiring Diagram Speaker ConnectionsSpeaker HEX Mode G5-900 Adjustments FRONT/REAR Panel 2CHANNEL 4CHANNELFRONT/REAR Panel 4CHANNEL 5CHANNELTrouble Shooting Guide Specification G4-600 G4-800 G4-1000 G5-900 Warranty Interfire Audio, Inc