2.Join the vehicle’s audio and power supply cables to the female connectors of the Parrot MKi9000.
3.On the installation cable, connect the free yellow wire to one of the audio system’s corresponding
Car stereo with line-in jacks
•Use this type of connection by wiring a
•Using the two pairs of
•On the installation cable, connect the free yellow wire to one of the audio system’s corresponding
With this type of
Car stereo without ISO connectors
To simplify the wiring procedure, you will need to purchase an ISO adapter cable. Refer to the range of ISO adapters on our website: www.parrot.com.
Installing the kit’s power cable
•Refer to your car stereo’s wiring diagram.
•The red wire of the kit’s cable must correspond to the constant +12V supply, the orange wire to the ignition +12V and the black wire to ground.
•Check that the orange wire is not connected to the constant +12V supply, as you could run down the vehicle’s battery, preventing your
•On some vehicles, the red and orange power supply wires may need to be reversed. This can easily be done by reversing the two fuse holders on the Parrot MKi9000 installation cable.
On some vehicles, there is no ignition +12V on the vehicle’s connectors. You must therefore connect the orange power supply wire to the fuse box or another ignition power source.
Installing the audio connectors
•Connect the music cable to the electronic box and place the USB / iPod ® / Jack connectors into the glove box, the central console or the parcel tray depending on the configuration of your dashboard.
•To protect the connectors from dust, use the provided protection cap.
10