Writing a Program, Restoring Factory Preload data

CX3 EasyStart

!The Rotary Stop function can be assigned to a second PS-2 footswitch on a per-Program basis, for hands-free Rotary control!

Editing the Drawbar settings of a Program: “Live” drawbars in Drawbar Preset mode

1.Press the [EDIT] key, then press key #2. The Display reads “UPPER” and shows a graph of the programmed drawbar levels. The display is now in an interactive state: move the Upper drawbars, and the Display reflects the change Ä press the right cursor key [>] and the Display now reads “LOWER”: Now you can freely edit the Lower drawbars in the same manner.

2.To edit a Preset it is likely that you will want to first get the drawbars set exactly like the Preset. Just pay attention to the display, and move each of the nine drawbars until they catch up with the original settings in the display. Then you can make changes with the physical drawbars, accurately represeting what was stored.

Tip: Edit Mode remembers the Edit page you ‘parked’ on the last time you used it. When you select another Program and press the EDIT key, the display returns you to Group 2, the Drawbar Edit page.

Splitting the keyboard, Changing Split Point, Changing the Octave

1.Select Program A-3 Felix’s Da Kat. To split the keyboard, press the SPLIT key (it will light).

2.To change the Split Point, press the EDIT key, then press key #7. The display says “Split Point:” Press the [-]key once to change the Split Point from C4 to B3.

3.To change the octave of the lower manual sound (below the split), press the [>] CURSOR key twice, so that the display reads “Split Lower Octave: ” Ä press the [+] key twice to raise the lower area of the keyboard two octaves.

!These edits will not be retained unless they are written to the Program.

Writing a Program

1.Press the WRITE/ENTER key. The display reads ”WRITE “. Note the speaker icon: when it is next to the left Bank/Program#, it allows you to hear the edited Program in the buffer.

2.Press the [>] CURSOR key once, and the speaker icon moves to the right Bank/Program #. This allows you to audition the destination Program before you destructively write over it. Use the [+] or [-]keys if you wish to find another destination.

3.Press the WRITE/ENTER key twice to execute the Write operation.

Restoring Factory Preload data

1.Hold down keys #2 and #7 while turning on the power (power switch located on the back of the CX-3).

2.The display will prompt “Load Factory Data?” Ä press the WRITE/ENTER key to complete the operation.