RMT2-IR Installation

1.Remove battery cover from the back of the RMT2-IR remote.

2.Verify that dip switches 1 & 2 are in the down (OFF) position. (See page 6)

3.Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down.

4.Test the RMT2-IR remote by pressing ONLY one button at a time. The indicator light on the remote will flash once each time you press a button.

WARNING: Do not press multiple buttons simultaneously and do NOT press buttons rapidly. These actions will cause the remote to reset and steps 1-4 will have to be repeated.

Note: The RMT2-IR ships with two batteries. One battery is required for operation, the second battery is complimentary.

The optional IR extender allows you to relocate your HDMI Switcher and still retain IR control. Linear part# IR-EXTENDER