IR CODE CONFIGURATION
How to Resolve IR Code Conflicts
In the event that IR commands from other remote controls conflict with the supplied
NOTE: *DIP SWITCHES 1, 2, and 5 through 8 are not used on the 2:8 Distribution Amplifier for HDMI.
Because the procedure for changing channels requires the main unit to be disassembled, this procedure should only be done if there are IR conflicts present in your setup.
Disconnect power from unit before starting. Remove all cabling from unit.
To open the 2:8 Distribution Amplifier for HDMI Unit, remove all screws from the sides and underside of the unit. Remove the hex nuts above each HDMI connector. Slide the unit apart carefully to expose the internal PCB and the 8 DIP SWITCH bank.
When DIP SWITCH adjustments are complete, carefully slide the unit back together. Being careful not to over tighten the hex nuts, screw them back in above each HDMI connector. Screw all of the screws from the sides and underside of the unit back into the unit, again being careful not to over tighten the screws. Plug all cabling back into its proper location on the unit. Reconnect power to the unit and test for IR conflicts.
Remote
Remote Channel 1: |
|
|
|
| Remote Channel 2: |
|
|
|
|
|
|
|
|
|
|
|
| ||
Default |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 | 2 |
| 1 | 2 |
| ||||
|
|
|
|
|
|
|
| ||
Remote Channel 3: |
|
|
| Remote Channel 4: |
|
|
|
| |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 | 2 |
| 1 | 2 |
| ||||
2:8 Distribution Amplifier for HDMI
Remote Channel 1: Default
Remote Channel 3:
1 2 3 4 5 6 7 8 |
1 2 3 4 5 6 7 8 |
Remote Channel 2:
Remote Channel 4:
1 2 3 4 5 6 7 8 |
1 2 3 4 5 6 7 8 |
7