Kathrein UFC 662sw manual Problem Cause Remedy, Troubleshooting

TROUBLESHOOTING

In the event of a malfunction, first check all the cable connections and operating states:

1.Receiver and TV set power plugs are connected to wall socket

2.Antenna cables are connected to the receiver input

3.Receiver and TV set are correctly connected to each other by a HDMI or Scart or cinch cable

4.Audio connections are made to the Hi-Fi or Dolby Digital system as appropriate

5.Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)

6.Receiver is responding to remote control

A selection of troubleshooting tips is offered below.

Problem	Cause	Remedy
		Check the cable connection
A “No signal!” warning appears	Antenna signal is absent	between your receiver
		and the cable socket.
on some or all channels	or is defective.
		Refer to your cable network
		operator or an antenna specialist.
		Set infrared code 1 as described
Remote control no	Receiver or remote control	in this manual under “Main
	command set may have been	menu settings”, “Basic settings”,
longer responding
	unintentionally changed	“Setting the remote control
		code”, check the batteries
		On “Settings” - “Date and Time”
		setup menu check “Summer
	“Summer Time” setting wrong.	Time Enabled” and change as
		necessary Use the power switch
Wrong time being displayed	An incorrect time was imported		change.
		to switch the receiver off from the
	from the reception signal
		current channel, e.g. Das Erste
		or ZDF, wait 10 seconds and	to
		then switch it back on
			936.3719/-/0110/ZWT - Technical data subject

Internet: http://www.kathrein.de KATHREIN-Werke KG • Anton-Kathrein-Straße 1 - 3 P.O. Box 100 444 • 83004 Rosenheim GERMANY