Loewe 42, 32, 37 operating instructions Configuring EPG

Electronic Programme Guide

Calling additional information about the programmes

žBrief information about some of the programmes is displayed below the programme list of the broadcasts.

You can call detailed information with the TEXT button if this function is offered by the TEXT icon in the lower left.

Programming a recording for a recorder

žžThe selection is in the lower programme list, if not, press the blue button.

Mark the desired programme.

Red button: Starts recording wizard.

Change or confirm timer data if necessary (see page 44, "The direct way to record“).

Then a red dot will be displayed in front of this programme as identification.

Red button: Deletes the already programmed recording of the red marked programme from the timer.

If the timer data have been transferred to an external recorder, then the timer must also be deleted there.

Configuring EPG

Start the EPG menu

žžEPG mode is started,

if not, press the EPG button. Call the EPG menu.

EPG menu		Data capture	INFO	END
rovider Station selection	OK		Switch on TV when marked	Sortin

Settings in the EPG menu:

Select Provider (only for analogue stations), Station selec- tion, Data capture, Switch on TV when marked, Sorting.

Explanations of setting possibilities in the EPG menu:

Select provider In analogue TV reception there may possibly be different providers who transmit the EPG data for certain station packages. To get another range of stations, you can change the provider with the Provider selection. If the provider you are looking for is not in the list, then use the yellow button to perform a Provider search.

The stations offered by the provider will be displayed in a list.

Station You can remove certain stations from the programme selection guide. These stations must be deactivated in the Station selection. First, all stations for which programme infor- mation can be provided are marked with a . Stations without a  are not included in the programme guide.

With the coloured buttons, you can select or deselect individual stations, select all stations at once or select only the stations in the favourites list.

Marking the stations according to reception ranges:

analogue stations via antenna/cable for the data supplied by the current provider.

digital terrestrial stations DVB-T,  digital cable stations DVB-C,  digital satellite stations DVB-S (1.

Data capture	If you want to use EPG for analogue and digital stations,
	select on (for DVB + analogue). If you want to use EPG
	and only have DVB reception, select on (only for DVB).
	If you are not using EPG and therefore do not want to
	receive any EPG data, select off.
	After making changes in the EPG menu, or each time the
	power switch has been switched off, the EPG data must
	first be captured. To do this switch on the device and
	select (for analogue stations) the station that you have
	defined as provider, and let the TV set run for about 1
	hour with the selected station. Or switch the TV set to
	standby mode. After 2 minutes the display on the TV
	lights orange and the EPG data capture begins. When
	the data capture process has concluded the display will
	return to red. The data capture process is usually per-
	formed between 2:00 am and 5:00 am, when the TV
	set is in standby mode.
Switch on TV	If the TV set is switched on then if there are memorised
when marked	programmes the TV set will switch over to these stations.
	If the TV set is in standby mode when a memorised pro-
	gramme begins, then you can specify here whether the
	set should be turned on in this case. If you have set "yes"
	in the menu, the TV set will be switched on. If you are
	not in at the time, a safety prompt makes sure that the
	TV switches off automatically after 5 minutes without
	your acknowledgement.
Sorting	The programmes can be sorted either according to their
	start time (sorting according to start time) or according to
	stations as in the station list (sorting according to station
	/ favourites list).
(1 if upgraded

31 -