Winegard MM-3002, MM-3084, MM-3200, MM-3003 installation instructions maximum separation

MM-3002 Assembly

STEP 9. Slip the small plastic shims over the handrail/ ladder and the large plastic shims over the MM-3084 pipe. See Figure 6.

Slip plastic clamp grips over pipes as shown (if using using rubber shims, place between clamp brackets and pipes).

NOTE: If MM-3002 comes with eight (8) rubber shims instead of the 4 plastic clamp grips. Insert rubber shims between clamp brackets and MM- 3001 pipie and handrail/ladder. See Figure 6.

STEP 10. Attach clamp brackets to pipe and handrail/ ladder using carriage bolts, nuts and washers supplied with MM-3002. Do not crush handrail/ladder. Try to maintain as much separation between the clamp brackets as possible. See Figure 7. Make sure pipe is vertical (straight up and down). Your now ready to aim the antenna; proceed to Operation, page 5.

	(4) 5/16-18
	Hex Nuts
FIGURE 6	(4) 5/16"
	Washers
(4) 5/16-18 x 1-3/4"
Carriage Bolts
Handrail/Ladder	Try to maintain
	maximum separation
	between clamps

MM-3084 Pipe with	MM-3084 Pipe with
MM-3002 Clamp Brackets	MM-3003 Clamp Brackets

FIGURE 7

Rev. 5/99

4