VDO Dayton CD 2537 U, CD 2327 G, CD 2217 G Software Access Menu SAM, Option Setting Usage

SOFTWARE ACCESS MENU (SAM)

It is possible to customize your headunit settings to your personal preferences via the SAM. To navi- gate the SAM, here are the steps:

	Short-press the		SAM	button to enter the SAM.
			AST
	Short-press	or			button to select the next SAM menu item; or short-press the or	but-
	ton to select the previous SAM menu item.

Turn the knob clockwise or counter-clockwise to choose the desired option.

Long-press the ASTSAM button to exit the SAM.

Note: The headunit will automatically exit SAM after 6 seconds of inaction.

Option	Setting	Usage
(◄/▼ or ►/▲) (turn the knob)
TAVOL	[1 to 26]	Select the volume level of Traffic Announcement, News bulletins
		and Alarm messages.
START	[1 to 26]	Limit the starting volume when the headunit is turned on (to pre-
		vent sudden loud surprise to the driver especially)
		 If the last-volume (before the headunit is turned off) is higher
		than the starting volume or muted, then after turning on, the
		turn-on volume is limited at the starting volume
		 If the last-volume is lower than the starting volume (except
		muted), the turn-on volume will be at the same level as the
		last-volume
CD LEVEL	[-2, -1, 0, +1, +2]	Select the Compact Disc volume offset relative to the tuner volume
CA LEVEL	[-2, -1, 0, +1, +2]	Select the Compressed Audio (MP3 or WMA) volume offset relative
		to the tuner volume
AUX LEVEL	[-2, -1, 0, +1, +2]	Select the Auxiliary volume offset relative to the tuner volume
BT LEVEL	[-2, -1, 0, +1, +2]	Select the Bluetooth volume offset relative to the tuner volume
BEEP	[OFF, ON]	Activate / Deactivate the confirmation beep tone
SDVC	[OFF, 1, 2]	Select the Speed Dependent Volume Control (SDVC) compensa-
		tion level (only when pin A1 is connected and calibrated; please
		refer to the ‚INSTALLATION‘ page)
		 Level 1 gives a smaller increase (in volume) while level 2 gives
		a greater increase (in volume) with respect to the vehicle’s
		speed
SWRC	[OFF, ON]	Activate / Deactivate the steering wheel remote control
TEL MUTE	[OFF, LO, HI]	Select the logic level of your connected hands-free car kit (HFK)
		mute cable
		 Select ‘TELM OFF’ if no HFK is connected
		 Select ‘TELM LO’ if the incoming HFK mute signal is at 0V
		 Select ‘TELM HI’ if the incoming HFK mute signal is at 12V
		Please refer to the instruction manual of your purchased HFK.
CLOCK	[OFF, RDS,	Select ‚CLOCK RDS‘ to activate the RDS clock or ‚CLOCK MAN‘ to
	MAN]	set the clock manually.
		Note: Selecting ‚CLOCK OFF‘ will disable the clock display when
		the headunit is in stand-by / off mode; hence, it will help prolong
		your battery.
CLOCK SET	[12H hh:mm,	If ‚CLOCK MAN‘ is selected, this menu item is available for cus-
(available	24H HH:MM]	tomization.	or
when 'CLOCK		 Short-press		button to select the 12H/24H-digit,
MAN' is se-		hour-digit or minute-digit
lected)		 Rotate the knob to adjust the selected digits

English

25