Pioneer AVH-P5100DVD English Español Deutsch Français Italiano Nederlands PyÒÒÍËÈ

Page 3

Note:

This unit cannot be installed in a vehicle with- out ACC (accessory) position on the ignition switch.

 

 

CC

 

 

 

 

 

 

 

 

 

F

A

O

 

 

 

F

O

 

 

 

 

N

 

N

O

F

 

 

 

 

O

F

 

 

 

 

 

 

 

S

 

 

 

S

 

 

 

 

 

 

 

 

 

 

 

 

 

 

T

 

 

 

 

T

 

 

 

 

R

A

 

 

 

R

A

 

 

 

T

 

 

 

T

 

 

 

 

 

 

 

 

 

 

ACC position

No ACC position

Use this unit in other than the following condi- tions could result in fire or malfunction.

Vehicles with a 12-volt battery and negative grounding.

Speakers with 50 W (output value) and 4 ohm to 8 ohm (impedance value).

To prevent short-circuit, overheating or malfunc- tion, be sure to follow the directions below.

Disconnect the negative terminal of the bat- tery before installation.

Secure the wiring with cable clamps or adhe- sive tape. To protect the wiring, wrap adhe- sive tape around them where they lie against metal parts.

Place all cables away from moving parts, such as gear shift and seat rails.

Place all cables away from hot places, such as near the heater outlet.

Do not pass the yellow cable through a hole into the engine compartment to connect to a battery.

Cover any disconnected cable connectors with insulating tape.

Do not remove RCA caps if RCA cables are not used.

Do not shorten any cables.

Never cut the insulation of the power cable of this unit in order to share the power to other equipment. Current capacity of the cable is limited.

Use a fuse of the rating prescribed.

Never wire the speaker negative cable direct- ly to ground.

Never band together multiple speaker’s nega-

tive cables.

Control signal is output through blue/white cable when this unit is powered on. Connect it to an external power amp’s system remote control or the vehicle’s auto-antenna relay control terminal (max. 300 mA, 12 V DC). If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal.

Never connect blue/white cable to external power amp’s power terminal. Also, never con- nect it to the power terminal of the auto antenna. Otherwise, battery drain or malfunction may result.

IP-BUS connectors are color-coded. Be sure to connect connectors of the same color.

Black cable is ground. This cable and other prod- uct’s ground cable (especially, high-current prod- ucts such as power amp) must be wired separate- ly. Otherwise, fire or malfunction may result if they are accidentally detached.

English Español Deutsch Français Italiano Nederlands PyÒÒÍËÈ

2

Image 3
Contents AVH-P5100DVD Contents Connecting the UnitsEnglish Español Deutsch Français Italiano Nederlands PyÒÒÍËÈ Parts supplied Español Deutsch Français Italiano Nederlands Connecting the power cord LeftRight Connection method Front Output When connecting to separately sold power ampLeft Right Rear View Camera When connecting with a rear view cameraEnglish Español When connecting with a multi-channel processorConnect the optical cable and ground lead to the main unit Connecting and installing the optical cable connection boxWhen connecting the external video component and the display DIN Front/Rear-mount InstallationDIN Front-mount Remove the trim ring and the mounting sleeveDecide the position of the side brackets DIN Rear-mount Install the unit into the dash- boardTighten two screws on each side Fastening the front panelTable des matières Raccordements des appareilsRemarque Pièces fournies English Branchement du cordon d’alimentation GaucheDroit Remarque Méthode de connexionOutput Gauche Droit Raccordements à une caméra de recul English Français Lors du raccordement d’un processeur multi-canauxRaccordement du câble à fibres optiques Español Français Raccordements à un appareil vidéo externe et à un écranMontage DIN avant/arrière Montage DIN avant Retirez la plaque de garniture et le manchon de montageDécidez la position des supports latéraux Montage DIN arrière Installez l’appareil dans le tableau de bordVissez deux vis de chaque côté Fixation du panneau avantContenido Conexión de las unidadesNota Piezas suministradas Français Italiano Nederlands Conexión del cable de alimentación IzquierdaDerecha Nota Método de conexiónDEQ Output Izquierda Derecha Precaución Cuando conecte con una cámara de vista traseraFrançais Cuando conecte con un procesador multicanalConexión del cable óptico Español Français Cuando conecte el componente externo y la pantallaMontaje delantero/trasero DIN InstalaciónMontaje delantero DIN Quite el anillo de compensación y el manguito de montajeDecida la posición de las ménsu- las laterales Instale la unidad en el tablero de instrumentos Montaje trasero DINApriete los dos tornillos en cada lado Fijación del panel delanteroCRD4404-A/N UC
Related manuals
Manual 104 pages 49.19 Kb Manual 104 pages 2.13 Kb

AVH-P5100DVD specifications

The Pioneer AVH-P5100DVD is a multifunctional multimedia receiver designed to enhance the in-car entertainment experience. This device combines advanced technology with user-friendly features, making it a popular choice among car audio enthusiasts.

One of the standout features of the AVH-P5100DVD is its 7-inch touchscreen display. The high-resolution screen provides vibrant colors and sharp images, allowing users to easily navigate through menus and access their favorite media. The intuitive layout makes it simple to control various functions, from adjusting volume to selecting playlists.

With support for both DVDs and CDs, the AVH-P5100DVD allows users to enjoy video and audio entertainment while on the road. It also includes a built-in AM/FM tuner, enabling access to a wide range of radio stations. The device is compatible with MP3, WMA, and AAC file formats, allowing for versatile playback options.

Bluetooth connectivity is another key feature of the AVH-P5100DVD, enabling hands-free calling and audio streaming directly from a smartphone. This feature enhances safety by allowing drivers to focus on the road while managing calls and music wirelessly. Additionally, the device is compatible with both Android and iOS smartphones, providing seamless integration.

Pioneer's MIXTRAX technology further enriches the listening experience by creating a DJ-like experience. This feature analyzes the music library and seamlessly blends tracks together, allowing for uninterrupted playback. Moreover, the AVH-P5100DVD supports various audio customization options, including a 13-band graphic equalizer and built-in crossover. This gives users the ability to tailor sound settings according to their preferences, ensuring an optimal audio experience.

For those who wish to extend functionality, the AVH-P5100DVD supports various external devices. It features multiple RCA outputs, allowing for the connection of additional amplifiers or subwoofers. The device also includes a USB port for direct connection to USB-compatible devices, enabling quick access to media files stored on flash drives.

In summary, the Pioneer AVH-P5100DVD stands out for its advanced multimedia capabilities, intuitive interface, and high-quality audio performance. With its combination of tech-friendly features and customizable settings, it caters to a wide range of users, making it an excellent choice for enhancing the in-car entertainment experience. Whether you’re a casual listener or an audiophile, the AVH-P5100DVD offers something for everyone.