Calibre UK 270303 manual Product Specification, NTSC, PAL, Secam

CALIBRE

PRODUCT SPECIFICATION

4.1.Introduction

This section provides technical details for all possible inputs please refer to the model specification to determine which inputs can be displayed by the monitor.

4.6Power Supply Requirement

Unless otherwise specified on the product the supply voltage MUST be from a clean 12V±1% supply.

The power supply rating depends on the requirements of the display panel, please refer to the model specification for details.

4.2.	Video Inputs
	Signal formats	Composite (CVBS), S-Video (Y/C), SDI, DVI
	Standards	NTSC, PAL, SECAM
	Composite (CVBS) input level	1V p-p nominal inc. sync
	Luminance (Y) input level	1V p-p nominal inc. sync
	Chrominance (C) input level	0.6V p-p nominal
	Input Impedance (all inputs)	75 Ohms

4.3.Computer (RGB and DVI) Inputs

Signal formats: DOS	720 x 400	70Hz
VGA	640 x 480	50Hz to 75Hz inclusive
MAC I	640 x 480	67Hz
SVGA	800 x 600	50Hz to 75Hz inclusive
MAC II	832 x 624	74.7Hz
XGA	1024 x 768	50Hz to 75Hz inclusive
MAC 2	1152 x 870	75Hz
SXGA	1152 x 900	50Hz to 75Hz inclusive
SXGA	1280 x 1024	50Hz to 75Hz inclusive
UXGA	1600 x 1200	60Hz
RGB video level	0.7V - 1.0V
RGB input impedance	75 Ohms
Sync formats

1.Separate H & V sync at TTL levels.

2.Composite -ve sync at TTL levels.

3.Sync on green (an extra 0.3V -ve on the 0.7V 75 Ohm Green video signal)

4.4.	SDI Input
	Format:	Serial video data in SMPTE 270Mb/s format
	Input impedance:	75 ohms.

4.5.DVI Input

DVI input is via a Molex 88741 series or similar. Signals, which are in LVDS form are input via 100-ohm differential lines using TMDS coding. Maximum pixel clock rate is 165MHz, so that the maximum transition rate on the colour signals may exceed 1.5GHz.

Issue 4.03
27/03/03 Calibre UK Ltd 2003	Page 9