Bosch Appliances TC9217MM-W instruction manual Mm dia. holes to a minimum depth of 2.5

WARNING

•When installing BOSCH wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica- tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•	Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
•	Make sure that the wall will safely support four times the combined load of the equipment and all attached hard-
	ware and components.
	For Concrete Walls use wall arm (W), making sure	1
	that it is level, as a template to mark holes. Drill 1/			concrete
	4" (6 mm) dia. holes to a minimum depth of 2.5" (64			wall
	mm). Insert concrete anchors in holes flush with
	wall as shown (right). Place wall arm (W) over
	anchors and secure with #14 x 2.5" (6 mm x 65			ACC 204
	mm) wood screws (V). Tighten all fasteners.
	WARNING	Drill hole(s) and insert anchor(s)
		2
•	Tighten wood screws so that wall plate is firmly		wall arm
	attached, but do not overtighten. Overtightening can
	damage the screws, greatly reducing their holding
	power.			ACC 204
•	Never tighten in excess of 80 in • lb (9 N.M.).
•	Make sure that mounting screws are anchored into the	Place arm over anchor(s) and secure with screw(s)
	center of the studs. The use of an "edge to edge" stud	3
	finder is highly recommended.
	WARNING
•	Concrete anchors are not intended for attachment to
	concrete wall covered with a layer of plaster, drywall,	Tighten all fasteners
	or other finishing material. If mounting to concrete wall
	covered with plaster/drywall is unavoidable, plaster/
	drywall (up to 5/8" thick) must be counterbored as
	shown below. If plaster/drywall is thicker than 5/8",
	custom fasteners must be supplied by installer.
	CUTAWAY VIEW		ACC 204

	INCORRECT
wall	concrete
arm
	plaster/
	dry wall

	CORRECT
wall	concrete
arm
	plaster/
	dry wall

CONCRETE

WALL

W

V

6 of 12 ISSUED: 06-25-99 SHEET #: 039-9003-8 02-08-05