T I O N a L | Bosch Appliances TC9217MM-W guide

Attach support tray (A)

to vertical support arms

(P) as shown.

Note: Choose the square hole which aligns closest with the center of gravity mark on the TV (as determined in step 1). Attach anti-rollout hooks

Y R

(R) as shown using M6 screws (Z) and retainer bars (Y). Note: Extruded side of retainer bar (Y) goes towards anti-rollout hook (R).

Hand tighten only.

	O P T I O N A L
	Although top clamps (Q) and anti-rollout
A	hooks (R) [see step 7] will provide more than
A	adequate support for the TV, some installers
	may wish to also attach the support tray to
	the TV bottom.
	Using uni-clips (G) and M5 screws (F) (see
	instruction card in fastener pack), or #10 x
	3/4" particle board screws (H) and washers
TV	(I) (for attachment to mounting bosses if
(UPSIDE DOWN)	present), or a combination of both, attach
	support tray (A) to TV bottom. [To do this
	place TV upside down on a flat stable
	surface and position support tray upside
	down on TV bottom.] Attach at four places
	as close to the four corners of the TV bottom
	as possible.

G H I

4 of 12

ISSUED: 06-25-99 SHEET #: 039-9003-8 02-08-05

O P T I O N A L