3.Secure front of console using one ( 1 ) # 8 X 1 1/2" PWH screw (item 7) in front pocket of OEM secondary pod and light assembly. See Figure 17.
4.Install one ( 1 ) # 6 x 1 1/4" PWH screw (item 6 pg 2) in dimple area at front of console through front mounting bracket. See Fig. 17.
5.Tighten
in step 2.
10
1.Raise overhead console into approximate position and connect wiring to components.
2.Loosely fit console against headliner. Check that console is centered in vehicle and matches all contours of headliner. While supporting console in mounting position, loosely install using two (2)
Inspect wiring to make sure no chaffing has occurred near the rear bracket (Item 3).
Figure 17
Figure 19