BenQ FP92W user manual Connect the PC video cable, Connect the power cable to the monitor, Either

Page 9

2. Connect the PC video cable.

Do not use both DVI-D cable and D-Sub cable on the same PC. The only case in which both cables can be used is if they are connected to two different PCs with appropriate video systems.

Connect one end of the DVI-D cable to the monitor DVI-D socket and the other end to the DVI-D port on your computer. (optional)

The DVI-D format is used for direct digital connection between source video and digital LCD monitors or projectors. The digital video signals produce a superior quality picture than analog video signals.

Connect the plug of the D-Sub cable (at the end without the ferrite filter) to the monitor D-Sub socket. Connect the other plug of the D-Sub cable (at the end with the ferrite filter) to the computer video D-Sub socket.

Tighten all finger screws to prevent the plugs from acci- dently falling out during use.

3. Connect the power cable to the monitor.

Plug one end of the power cord into the socket labelled ‘POWER IN’ on the rear of the monitor. Do not connect the other end to a power point just yet.

Either

Or

How to assemble your monitor hardware

9

Image 9
Contents Welcome Copyright Table of Contents Getting started Power Cord Signal Cable D-SubSignal Cable DVI-D optional Power AC input jack DVI-D input socket Sub input socket Getting to know your monitorFront view Back view Power Enter Brightness Contrast Left-side viewInput Key Attach the monitor base How to assemble your monitor hardwareConnect the power cable to the monitor Connect the PC video cableEither Route the cables via the cable clip Prepare the monitor and area How to detach the stand baseHow to use the monitor wall mounting kit PrecautionsRemove the monitor stand Remove the rear cover Getting the most from your BenQ monitor How to install the monitor on a new computer See How to upgrade the monitor on an existing computerOpen Display Properties How to install on Windows XP systemHow to install on Windows 2000 system How to complete the Windows Upgrade Device Driver Wizard Open Display Properties and select the Settings tab How to adjust the screen resolutionClick OK then Yes Close the Display Properties windowHow to adjust the screen refresh rate Picture optimization Control panel How to adjust your monitorPicture On Screen Display OSD menu structureHot key mode Brightness hot keyContrast hot key Main menu mode Function Operation Range Display menuPress the tor ukeys to adjust the value Picture menu Setting is 50. Decreasing One or more of the colors Image. The default startCustom color settings to Adjust the value Factory defaults BlueSystem menu Position Adjusts the vertical Position Adjusts the horizontalAccidentally changed When this function is DisabledFrequently asked questions FAQ TroubleshootingImage is distorted, flashes or flickers Need more help?Supported PC Timings BenQ FP92W SpecificationsSpecifications