Blaupunkt DVD-ME1 manual Monitor External Remote Sensor

PREPARATIONS BEFORE OPERATION

Connect to a Mobile Amplifier Turn off all the equipment before connections.

Monitor

External

Remote

Sensor

Video In

	REMOTE IN
	VIDEO OUT
	R		L
	AUDIO OUT
	DC	12V	1.5A
+	Filter
12V Fuse			Audio In
–

Mobile Amplifier

In the connection diagram, the system’s power leads should be connected at the same point to minimize noise.

Connect to a TravelPilot DX-N Navigation System Turn off all the equipment before connections.

DX-N Monitor Cable

(supplied with DX-N)

DX-N Main Unit (Rear View)

Video Converter	Pin 1: 12vdc Constant	5	6
	Pin 2: Ground
7 607 005 718	Pin 3: Reverse Trigger	3	4
	Pin 4: 12vdc Output
	Pin 5: 12vdc Ignition	1	2
	Pin 6: Video Trigger (Plus=FBAS)

InputOutput Video In

15 Pin Serial Cable	RCA Cable
(supplied with converter)

Video Line Output

DVD-ME1

■This schematic describes the installation of an After Market video source, such as VCR, DVD, TV Tuner, or Video Game, connected to a Blaupunkt DX-N Navigation System through a Blaupunkt Video Converter, P/N 7 607 005 718. The Video Converter is necessary to convert the source’s video signal into a usable format for the DX-N.

■Signal connections include: (a) RCA connection from the video source’s output to the converter’s input, (b) 15 pin serial connection between the converter' s output and the DX-N ROM 15 pin input, and (c) DX-N ROM connection to the DX-N screen, using the supplied video cable.

■Note: When using a gooseneck mounting adapter, P/N 7 612 001 204, the supplied cable will take the place of the DX-N monitor cable supplied with the DX-N package.

■Note: Video source audio connection can be made via RF modulator to any factory radio or via RCA cable through an After Market radio if an auxiliary input is available.

DX-N Screen

– 9 –