Blaupunkt DVD-ME1 manual Safety Concerns

SAFETY CONCERNS

We always recommend you have your Blaupunkt DVD/MP3 player professionally installed but the installation process is often so easy that the average consumer can achieve success with little trouble. All operating instructions should be followed. Regardless of person installing, you should be sure to review the following points before proceeding with the installation:

■READ THE MANUAL! Understanding the product and installation limitation before lifting a screwdriver. Follow Instructions -

■POWER SOURCES - Make sure to use operate only from the type of power source indicated on the rear panel. For products intended to operate from battery power, or other sources, refer to the operating instructions. Do not overload the power source to prevent a risk of fire or electric shock.

■POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

■POWER CABLE - Make sure to route power cables appropriately so that they are not likely to be walked on or pinched by items placed upon or against them, paying special attention to cords at plugs, convenience receptacles, and the point where they exit from the product.

■CLEANING - Disconnect this product from the power source before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth.

■WATER & MOISTURE - Do not use this product near water.

■ACCESSORIES - Do not place this product on an unstable object. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer.

■LIGHTNING - During a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the power source prevent damage to the product due to lightning and power-line surges.

■OBJECT & LIQUID ENTRY - Never push objects of any kind into this product and/or liquid entry to product could result in a fire or electric shock.

■SERVICING - Any attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards.

■DAMAGES REQUIRING SERVICE - Disconnect this product from the power source and refer servicing to qualified service personnel under the following conditions;

a)Damage to the power cord or plug

b)Water damage

c)Product malfunction or change in performance

d)If the product has been dropped

■PART REPLACEMENT - Make sure to use the replacement parts specified and/or approved by the manufacturer to prevent potential fire, electric shock or other hazards. Upon completion of any service or repair, be sure to perform safety checks by qualified service personnel.

■WEAR SAFETY GLASSES AT ALL TIMES - Flying debris are always dangerous.

■PROTECT THE VEHICLE - Always disconnect the negative battery cable before starting any kind of installation work. This prevents a possible high current electrical short (potential fires).

■HEAT - Keep all products away from nearby hot components such as amplifiers, radiators, heat registers, stoves or vehicle components that heat up over time such as hoses, high current wires, and braking systems components. Make sure to leave enough room for ventilation on openings and slots to protect if from over-heating.

■GIVE YOURSELF LOTS OF TIME - Rushing to complete an installation nearly always ends up with problems.

■WHILE DRIVING, KEEP EYES ON THE ROAD AND NOT ON THE MONITOR. KEEP THE VOLUME LOW.

Please record the model and serial number located at rear panel.

Model No. Serial No.

– 3 –