5.23.2 LANGUAGE SETUP
OSD LANGUAGE
This item is for selecting the language of the SYSTEM MENU and all operating prompt interface displayed during playback.
AUDIO LANG
This item is for selecting a audio language.
SUBTITLE LANG
1.8 UNIT INSTALLATION
INSTALLATION INSTRUCTIONS
This is an
The main unit has a METAL MOUNTING SLEEVE.
Please connect the wiring, eg, the Power supply, the Speakers and the Antenna according to the requirements of this Instruction Manual, then install the metal mounting sleeve into the car as per the diagram illustrated below.
This item is for selecting a subtitle language.
MENU LANG
This item is for selecting a disc menu language.
5.23.3 AUDIO SETUP
AUDIO OUT
there is only ANALOG mode, i.e. SPDIF/OFF,
METAL STRAP
DASH BOARD
For optimum
To properly fix the metal mounting sleeve, bend the tabs of the sleeve against the DASH BOARD with a screwdriver.
UNIT CHASSIS
PLASTIC TRIM OUT
not optional.
KEY
It is for selecting your desired basic music tone (from low to high).
5.23.4 VIDEO SETUP
BRIGHTNESS
It is for adjusting the brightness of the video output.
CONTRAST
It is for adjusting the contrast of the video output.
HUE
It is for adjusting the hue of the video output.
SATURATION
It is for adjusting the saturation of the video output.
SHARPNESS
It is for adjusting the sharpness of the video output.
SLIDING METAL HOUSING |
| FRONT PANEL |
|
TO DRAW THE CHASSIS OUT OF
THE SLIDING METAL HOUSING,
INSERT THE LEFT AND RIGHT KEY
PLATES INTO THE RIGHT POSITION
OF THE 2 SIDES OF CHASSIS.
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com