1.7 Wires Connection Description
Description of Wires Connection
Fixing Screw Bolt | Wiring Connecting Socket 1 |
GREEN |
|
|
|
|
|
|
|
Wiring Connecting Socket 2 | PARKING LINE | Black | Radio Antenna jack | Black | ||
|
| WHITE |
|
| ||
REVERSAL LINE 
Black
USB LINE IN
1.Parking wire must be connected. And the parking brake must be engaged in order for the monitor to work.
2.Use the clip end of the Ground Wire provided by manufacturer to connect Mounting Screw, using the other end of the Ground Wire to connect the negative pole of the power source. Otherwise, the video on screen maybe flashes.
Description of the Wiring Diagram for Socket 1
|
|
|
|
|
|
| WIRING CONNECTING SOCKET 1 | ||||
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
| WIRING CONNECTING PLUG 1 | ||||
ISO CONNECTOR |
|
|
| ||||||||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
| ||||||
MEMORY B+YELLOW FUSED |
|
| WOOFER LINE OUT | ||||||||
BLACK(GND) | FILTER |
|
|
|
|
|
| GREEN | |||
BOX 1A |
|
|
|
|
|
|
|
| |||
| & 10 A |
|
|
|
|
|
|
|
| ||
IGNITION SWITCH RED |
|
| BLACK |
| RED R | ||||||
FUSES |
|
|
| ||||||||
| FRONT AUDIO RCA OUT |
| WHITE L | ||||||||
BLUE AUTO ANT |
|
| |||||||||
|
|
|
|
|
|
| |||||
FRONT | WHITE |
|
| GRAY | FRONT | ||||||
LEFT | WHITE / BLACK |
|
| GRAY / BLACK | RIGHT | ||||||
|
|
|
|
|
|
|
|
| |||
SP | GREEN |
|
| VIOLET | SP | ||||||
REAR | GREEN / BLACK | VIOLET / BLACK |
| REAR | |||||||
|
| ||||||||||
|
|
| |||||||||
NOTES:
1.Only speakers with 4 ohms impedance may be used.
2.Ensure that the blue auto antenna cable does not make contact with any ground connection.
Description of the Wiring Diagram for Socket 2
|
|
|
|
| WIRING CONNECTING SOCKET 2 | |||
|
|
|
|
| ||||
RED R |
| BROWN |
|
| WIRING CONNECTING PLUG 2 | |||
|
|
| ||||||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
WHITE L |
|
|
|
|
|
|
| |
| AV RCAAUX IN |
| GREY |
|
| RED R | ||
YELLOW VIDEO |
|
|
|
| ||||
|
|
|
|
| ||||
YELLOW |
| GREY | REAR AUDIO RCA OUT |
|
| WHITE L | ||
| ||||||||
|
|
|
|
|
|
|
| |
YELLOW |
| VIDEO RCA OUT |
| BLACK |
| IPod IN | ||
|
|
| ||||||
|
| BLACK |
|
|
|
| ||
YELLOW |
| REAR VIEW CAMERA |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Description of Connecting the Parking Brake Line to the Parking Brake System Built in a Car
Parking brake
| Parking brake wire(Green) |
Parking brake switch | To metallic body or chassis of the car |
(inside the car) |
|
NOTE: after connecting the Parking Line, the video on the small monitor of the front panel will be display only after br aking the car.
5.23.5 SPEAKER SETUP
DOWNMIX
This is for selecting your desired sound effect when there is no center speaker and subwoofer. There are 3 modes: LT/RT, STEREO, VSS. LT/RT: When playing a disc with PRO LOGIC
stereo effect, choose the item, so it will output audio signal with vivid theatre effect.
STEREO: If you choose the item, when outputting audio signal with 5.1 channels, it will output the left and right channels of signal ; when outputting audio
signal with 2 channels, it will output the common 2 channels of stereo signal. VSS: If you choose the item, when playing a disc recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.
5.23.6 DIGITAL SETUP
OP MODE
This is for selecting audio output mode LINE OUT: It can linearly compress the
audio signal. So the volume level is lower. You should select the item at night.
RF REMOD: It can make the volume level higher. You should select it at daylight.
DYNAMIC RANGE
After selecting the compression mode of LINE OUT, set the item, so you can adjust the linear compression ratio. If you set it to be FULL, the
DUAL MONO
This is for selecting a desired audio output mode for left and right signals. It is mainly for Karaoke of Ac3. There are 4 modes in all as follows:
STEREO, MONO L, MONO R, MIX MONO.
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com