Pioneer SC-35 manual Operating this receiver by RF communications

10Controlling the rest of your system (In case of SC-37)

Pairing the RF adapter and remote control

Pairing is necessary in order to use the RF communications function. Perform the operation below after connecting the RF adapter and receiver.

1Switch on the receiver.

2Set the RF Remote Setup on this receiver’s Other Setup menu to ON.

For details, see RF Remote Setup (SC-37 only) on page 120

3Press the SETTING button on the front of the RF adapter.

RF adapter’s LED blinks red.

4While pressing MULTI OPERATION, press VIDEO PARAMETER on the remote control.

The remote display shows PAIRING.

5Press ENTER on the remote control. AUTHORIZATION flashes and pairing is performed. When pairing is successful, SUCCESS is displayed and pairing is completed. RF adapter’s LED lights green.

The display on the receiver itself is displayed on the

remote control’s display. For details, see Remote control display on page 13.

If ERROR is displayed, pairing has not been successful. Check the connections and distance with the RF adapter, then start over from step 1.

The remote control unit’s receiver operation mode must be set to “RF” in order to operate the receiver with RF two- way communications. Make this setting as described at Operating this receiver by RF communications below.

Operating this receiver by RF communications

Use this procedure to make the remote control settings to operate the receiver using RF two-way communications. The settings can be made individually for the main zone, ZONE 2 and ZONE 3. Connect the receiver and RF adapter and pair the RF adapter and remote control unit beforehand.

3Use / to select the receiver zone for which you want to use RF two-way communications, then press

ENTER.

4Use / to select ‘RF MODE’, then press ENTER.1 Select IR MODE to return to operation by infrared signal.

5If you want to operate other zones with RF two- way communications, repeat steps 3 and 4.

Operating other components by RF communications

Up to 4 other components connected to the receiver can be operated by RF communications. Use the IR blaster to communicate between the RF adapter and other components, and switch the remote control’s setting to RF. The remote control’s setting can be switched individually for each input.

To mount on a shelf above the component

Double-faced tape

Remote control sensor

Rack

To mount on the component

1While pressing MULTI OPERATION, press HOME MENU.

The remote display shows SETUP MENU.

2Use / to select ‘IR/RF SELECT’, then press

ENTER.

Check that the units are paired. If RECEIVER MAIN is displayed, pairing has been performed properly, so proceed to step 3. If RF MODE ONLY flashes, pairing has not been performed properly, so perform this procedure again after performing pairing (see Pairing the RF adapter and remote control on page 92).

Double- faced tape

Remote control sensor

Note

1When RECEIVER is selected and RF MODE is set at step 3, HMG NET RADIIO, ADAPTER, iPod USB and TUNER are automatically set to the RF mode. Note that RF MODE cannot be set for OPTION 1 and OPTION 2.

92

En