Pioneer SC-35 Using the RF communications function, IR blaster only required when you want to

Controlling the rest of your system (In case of SC-37) 10

Using the RF communications function

IR blaster (only required when you want to
operate other components by RF two-way
communications) (max. 4 components)	Y	PB	PR
			ANTENNA
			AM LOOP	FM UNBAL 75
	RS-232C		CONTROL	IN 1	IR
			IN
	(OUTPUT 5 V			IN 2
	150 mA MAX)		OUT
	CU-RF100				OUT
	Receiver

Operation of the receiver or other

components placed in a rack is possible

Operation is possible in any direction the remote control is pointed (360°)

RF Adapter

Remote control operation

With this receiver, two-way communications between the receiver and remote control are possible by connecting the included RF adapter to the RS-232C and CU-RF100 terminals. For instructions on connecting the RF adapter, see Connecting the RF adapter (SC-37 only) on page 21. Two-way communications allow you to use the following functions:

•The receiver can be operated by pointing the remote control in any direction (360°) (maximum line-of-sight distance for two-way communications: about 10 meters).

•Operate is possible without being affected by obstacles (even products in racks can be operated).

•The information shown on the receiver’s display can be displayed on the remote control’s display as you operate.

•RF communications can be used to operate up to 4 other components connected to the receiver (using the included IR blaster. For details, see Operating other components by RF communications on page 92).

•The remote control input display names can be synchronized with the input names changed at Input Name on the receiver’s Input Setup menu (page 45) and acquired automatically. For details, see Renaming input function names in synchrony with the receiver on page 93.

•When the receiver’s input is switched, the remote control’s display and operating mode switch to that input automatically. For details, see Setting the remote control operation mode on page 94.

Important

•The line-of-sight communications distance is a rough indication, and may differ according to the surrounding environment.

•Depending on the communications environment, functions using two-way communications between the receiver and remote control may not operate properly. For details, including cautions on the communications environment and usage procedure, etc., see Precautions when using the Omni- Directional RF Remote Control on page 94.

Note

•You can cancel or exit any of the steps by press and hold MULTI OPERATION for a couple of seconds. To go back a step, press RETURN.

91

En