Erasing the settings for the multi-operation

10Controlling the rest of your system (In case of SC-35)

Programming a Multi operation or a shutdown sequence

1Press and hold R.SETUP, then press “3” for three seconds.

The LED flashes continuously.

•To cancel the preset setup mode press R.SETUP.

2Press the input function button (or  SOURCE button).

For Multi operations, press the input function you wish to program (for example, if you want to start the sequence by switching on your DVD player, press DVD).1

For System off, press the  SOURCE button.

The LED blinks twice and flashes continuously.

3If necessary, press the input function button for the component whose command you want to input.

This is only necessary if the command is for a new component (input function).

4Select the button for the command you want to input.

The LED blinks once and flashes continuously.

•You don’t need to program the receiver to switch on or off. This is done automatically.

With Pioneer components, you don’t need to program the power to switch off in a shutdown sequence (except DVD recorders).

5Repeat steps 3 to 4 to program a sequence of up to five commands.

If you press R.SETUP before programming is completed, commands programmed up to that point will be stored.

6Press R.SETUP to exit the programming mode.

Using multi operations

1Press MULTI OPERATION. The LED flashes continuously.

2Within five seconds, press an input function button that has been set up with a multi operation. The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically.

Using System off

1Press MULTI OPERATION. The LED flashes continuously.

2Within five seconds, press  SOURCE.

The command sequence you programmed will run, then all Pioneer components will switch off2, followed by this receiver (switch of all the zones becomes off).