Pioneer SC-35 manual Enter, Select the ‘Passcode’ setting you want, Adapter

05Basic playback

Pairing the Bluetooth ADAPTER and Bluetooth wireless technology device

“Pairing” must be done before you start playback of Bluetooth wireless technology content using the Bluetooth ADAPTER. Make sure to perform pairing the first time you operate the system or any time pairing data is cleared. The pairing step is necessary to register the Bluetooth wireless technology device to enable Bluetooth communications.1 For more details, see also the operating instructions of your Bluetooth wireless technology device.

1Set the remote control to the receiver operation mode, then press HOME MENU.

2Select ‘System Setup’, then press ENTER.

3Select ‘Other Setup’, then press ENTER.

4Select ‘Pairing Bluetooth Device’, then press

ENTER.

5Select the ‘Passcode’ setting you want.

Select the same passcode as the Bluetooth wireless technology device you wish to connect.

•0000/1234/8888 – Select the passcode from these options. These are the passcodes that can be used in most cases.

•Others – Select to use a passcode other than those mentioned above.

6If you selected Others in step 5, enter the passcode. Use / to select a number and / to move the cursor.

7Follow the instructions displayed on the GUI screen to conduct pairing with the Bluetooth wireless technology device.

Switch on the Bluetooth wireless technology device that you want to make pair, place it near the receiver and set it to the pairing mode.

8Check to see that the Bluetooth ADAPTER is detected by the Bluetooth wireless technology device. When the Bluetooth wireless technology device is connected:

CONNECTED appears in the receiver display.2

When the Bluetooth wireless technology device is not connected:

Go back to the passcode setting in step 5. In this case, perform the connection operation from the Bluetooth wireless technology device.

9From the Bluetooth wireless technology device list,

select Bluetooth ADAPTER and enter the Passcode selected in step 5.3

Listening to music contents of a Bluetooth wireless technology device with your system

1SC-37 only: Set the remote control operation selector switch to SOURCE.

2Press ADAPTER on the remote control to switch the receiver to ADAPTER PORT input.4

3From the Bluetooth wireless technology device, perform the operation to connect to the Bluetooth

ADAPTER.

4Start playback of music contents stored on the Bluetooth wireless technology device.

This receiver’s remote control buttons can be used for

basic playback of files stored on Bluetooth wireless technology devices.5

SC-37:

	TV SOURCE RECEIVER		STATUS	PHASE CTRL		CH LEVEL
			THX	MPX	PQLS	MEMORY
CH	VOL	VOL
			AUTO/ALC/
			DIRECT	STEREO	STANDARD ADV SURR
			PGM	MENU

SC-35:

DIRECT STEREO STANDARD ADV SURR

HDD	DVD
THX	PHASE CTRL		STATUS
TV / DTV	MPX	PQLS
	HDMI OUT		AUDIO

1 2 3

The Bluetooth® word mark and logos are registered

trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Pioneer Corporation is under license. Other trademarks and trade names are those of their respective owners.

Note

1• Pairing is required when you first use the Bluetooth wireless technology device and Bluetooth ADAPTER.

•To enable Bluetooth communication, pairing should be done with both your system and Bluetooth wireless technology device.

2The system can display alphanumeric characters only. Other characters may not be displayed correctly.

3The passcode may in some cases be referred to as PASSKEY or PIN code.

4When the Bluetooth ADAPTER is not plugged into the ADAPTER PORT, NO ADAPTER will be displayed if ADAPTER PORT input is selected.

5• Bluetooth wireless technology device should be compatible with AVRCP profile.

•Depending on the Bluetooth wireless technology device you use, operation may differ from what is shown in the remote control buttons.

58

En