Pioneer SC-35 manual Home Media Gallery SC-37 only, Status messages Cause Action

Additional information 13

Status messages	Cause	Action
Check Sirius Tuner	The SiriusConnect™ tuner is not properly	Check that the 8 pin mini DIN cable and AC Adapter are
	connected.	attached securely.
Acquiring Signal	The SIRIUS signal is too weak at the current	Check for antenna obstructions and reposition the
	location.	SIRIUS antenna to get better signal reception. Use the
		Antenna Aiming option to optimize the antenna position.
Subscription Updating	Unit is updating subscription.	Wait until the channel subscription has been updated.
Updating Channels	Unit is updating the channel information.	Wait until the channel information has been updated.
Invalid Channel	Selected channel is not available/does not	Select another channel.
	exist.
Firmware Updating	The SiriusConnect™ tuner’s firmware is	Wait for updating to finish.
	being updated.

HOME MEDIA GALLERY (SC-37 only)

Symptoms	Causes	Remedies
Cannot access the network.	The LAN cable is not firmly connected.	Firmly connect the LAN cable (page 38).
	The router is not switched on.	Switch on the router.
	Internet security software is currently installed in	There are cases where a component with Internet
	the connected component.	security software installed cannot be accessed.
	The audio component on the network which has	Switch on the audio component on the network
	been switched off is switched on.	before switching on this receiver.
Playback does not start while	The component is currently disconnected from	Check whether the component is properly
‘Connecting...’ continues to	this receiver or the power supply.	connected to this receiver or the power supply.
be displayed.
The PC or Internet radio is not	The corresponding IP address is not properly set. Switch on the built-in DHCP server function of
properly operated.		your router, or set up the network manually
		according to your network environment
		(page 117).
	The IP address is being automatically configured. The automatic configuration process takes time.
		Please wait.
The audio files stored on	Windows Media Player 11 or Windows Media	Install Windows Media Player 11 or Windows
components on the network,	Player 12 is not currently installed on your PC.	Media Player 12 on your PC (page 64).
such as a PC, cannot be
	Audio files were recorded in formats other than	Play back audio files recorded in MP3, WAV
played back.
	MP3, WAV (LPCM only), MPEG-4 AAC, FLAC, and	(LPCM only), MPEG-4 AAC, FLAC, or WMA. Note
	WMA.	that some audio files recorded in these formats
		may not be played back on this receiver.
	Audio files recorded in MPEG-4 AAC or FLAC are	Audio files recorded in MPEG-4 AAC or FLAC
	being played back on Windows Media Player 11 or	cannot be played back on Windows Media Player
	Windows Media Player 12.	11 or Windows Media Player 12. Try using another
		server. Refer to the operation manual supplied
		with your server.
	The component connected to the network is not	Check whether the component is affected by
	properly operated.	special circumstances or is in the sleep mode.
		Try rebooting the component if necessary.
	The component connected to the network does	Try changing the settings for the component
	not permit file sharing.	connected to the network.
	The folder stored on the component connected to	Check the folder stored on the component
	the network has been deleted or damaged.	connected to the network.

133

En