Pioneer SC-35 Precautions regarding wavelength, Use / to select ‘OPERATION MODE’, then press

10Controlling the rest of your system (In case of SC-37)

Setting the remote control operation mode

• Default setting: ON

When the remote control operation mode is turned on and the receiver’s input is switched, the remote control display and operation mode switch automatically to that input. Select OFF if you do not want the remote control’s function to switch automatically when the receiver’s

input is switched.1

1While pressing MULTI OPERATION, press HOME MENU.

The remote display shows SETUP MENU.

2Use / to select ‘OPERATION MODE’, then press

ENTER.

Check that the units are paired. If SYNCHRO ON is displayed, pairing has been performed properly, so proceed to step 3. If RF MODE ONLY flashes, pairing has not been performed properly, so perform this procedure again after performing pairing (see Pairing the RF adapter and remote control on page 92).

3Use / to select ‘SYNCHRO ON’ or ‘SYNCHRO

OFF’, then press ENTER.

The remote display shows OK to confirm the setting.

4Press and hold MULTI OPERATION for a couple of seconds to exit and store the operation(s).

Precautions when using the Omni- Directional RF Remote Control

Precautions regarding wavelength

•This remote control is designed to prevent other persons from eavesdropping on the transmitted signals, but precautions should nonetheless be taken against the chance that other persons’ could intercept and listen to the signals transmitted. Given that this remote control produces radio wave transmissions, another person could deliberately use a receiver to attempt to intercept such transmissions. As a result, this device should not be used to play important transmissions demanding privacy.

This remote control utilizes the 2.4 GHz frequency band. This band is also used by a variety of other devices as noted below. In particular, devices not often cognizant to the user are listed in item 2.

1Examples of common devices utilizing the 2.4 GHz band:

•Cordless phone

•Cordless facsimile

•Microwave oven

•Wireless LAN router

•Wireless AV device

•Wireless controllers for games

•Microwave therapeutic devices

•Bluetooth wireless technology devices

2Other devices using 2.4 GHz:

•Shoplifting-prevention systems

•Amateur wireless radio

•Distribution control systems at factories and warehouses

•Railway and emergency vehicle wireless identification systems

When such devices are used simultaneously with this

remote control, signal interference may occur, resulting in signal dropouts.

To improve reception quality, try the following:

•Turn off the other device emitting radio waves.

•Place the interfering device farther away (Move both the remote control and RF adapter away from the interfering device).

Do not use this remote control in the following locations, since transmission interruption may result:

•Locations where another device using the same 2.4 GHz frequency is being used, such as a Bluetooth wireless technology device or wireless LAN, or in the vicinity where the magnetic field, static electricity, or radio wave interference from another device may occur (depending on the environment, radio waves may not transmit effectively).

•Move the radio farther away.

•If visual noise appears on the television screen, it is possible that this remote control is producing adverse influence on the antenna input of the television, video device, BS tuner, or CS tuner. Move this remote control farther away from the antenna input of the affected device.

Note

1• When the remote control’s input is switched, the receiver’s input also switches, but for functions for which the remote control direct function (page 86) is set to off, when the remote control’s input is switched, the receiver’s input does not switch and only the remote control unit’s operating screen switches.

• The remote control operation mode is only valid when the remote control operation selector switch is set to SOURCE.

94

En