Pioneer SC-35 manual Remote control, Web Control, Symptoms Causes Remedies

13Additional information

Remote control

Symptom	Remedy
Cannot be remote controlled.	• Set the remote control unit’s remote control mode so that it matches the setting on the main unit
	(see Operating multiple receivers on page 84 (SC-37)/page 96 (SC-35)).
	• Check whether the receiver’s remote control mode is properly set (see Remote Control Mode Setup
	on page 119).
	• Try replacing the batteries in the remote control (see Loading the batteries on page 10).
	• Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor on the front panel (see
	Operating range of remote control unit on page 11).
	• Check that there are no obstacles between the receiver and the remote control.
	• Make sure that there is no fluorescent or other strong light shining on to the remote sensor.
	• Check the connections of the CONTROL IN jacks (see Operating other Pioneer components with
	this unit’s sensor on page 41).
SC-37 only: Input does not	• Sirius and XM operations can no longer be performed if other preset codes are assigned to the
switch to Sirius or XM when	OPTION 1 (Sirius) or OPTION 2 (XM) button. In this case, reset the OPTION 1 or OPTION 2 button
OPTION 1 or OPTION 2 button	(see Resetting the input assignment of one of the input function buttons on page 86).
is pressed.
SC-37 only: Receiver or other	• There may be radio interference with other devices. Try increasing the distance from microwave
components cannot be	ovens, devices on a wireless LAN, other wireless devices, etc. (see Precautions when using the Omni-
operated by RF two-way	Directional RF Remote Control on page 94).
communications.	• Try replacing the batteries in the remote control (see Loading the batteries on page 10).
	• If the RF adapter’s LED is off, the RF adapter may not be properly connected to the receiver. Check
	whether the RF adapter is properly connected to the receiver (see Connecting the RF adapter (SC-37
	only) on page 21).
	• The devices may no longer be properly paired. Pair them again (see Pairing the RF adapter and
	remote control on page 92).
	• When the remote control or main unit are reset, the RF communications function is also reset.
	Make the settings again (see Using the RF communications function on page 91).
SC-37 only: The remote control	• Flickering may occur when the remaining battery power is low. Replace the batteries with new
display flickers.	ones (see Loading the batteries on page 10).
Other components can’t be	• If the battery ran down, the preset codes may have been cleared. Re-enter the preset codes.
operated with the system	• The preset code may be incorrect. Redo the procedure for entering preset codes.
remote.	• When commands from the remote control units of other devices are registered using the learning
	function, in some cases they may not be learned properly. In this case, register the commands again
	using the learning function (see Programming signals from other remote controls on page 85 (SC-37)
	/ page 97 (SC-35)). If they still do not work, they may be in a special format that cannot be registered
	on this receiver’s remote control. Operate the device using another remote control.

Web Control

Symptoms	Causes	Remedies
Top Menu screen is not	This receiver’s IP address has not been entered	Check the receiver’s IP address and enter it
displayed on browser.	into the browser correctly.	correctly in the browser (page 117).
Receiver cannot be operated	JavaScript is disabled on the internet browser.	Enable JavaScript.
from browser.
	The browser is not compatible with JavaScript.	Use an internet browser that is compatible with
		JavaScript.

Receiver’s power does not turn on when the power is turned on using the Web Control function.

Network Standby at Network Setup is set to OFF.

Set Network Standby at Network Setup to ON (page 118).

128

En