Pioneer SC-35 Controlling the rest of your system In case of SC-37, About the Remote Setup menu

Controlling the rest of your system (In case of SC-37) 10

Chapter 10:

Controlling the rest of your system (In case of SC-37)

Important

•This section includes explanations for the SC-37’s remote control. For instructions for the SC-35’s remote control, see Controlling the rest of your system (In case of SC-35)on page 96.

About the Remote Setup menu

The Remote Setup mode is set by pressing the HOME MENU button while pressing MULTI OPERATION. The different items on the Remote Setup menu are described below. For their setting procedures, refer to the explanations for the respective items.

Setting What it does

PRESET Preset codes can be set for the various input

RECALL functions. The remote control codes of a number of other devices (including products of other brands) are preset in the remote control to allow these devices to be operated. See “Selecting preset codes directly” on page 84.

CODE If the desired operations cannot be performed LEARNING even though you have set the preset codes, the remote control signals of other devices can be

learned directly. See “Programming signals from other remote controls” on page 85.

MULTI A series of the remote control operations for OPERATE starting listening or viewing can be programmed.

Multiple remote control codes can be set for the different input functions. See “Multi Operation and System Off” on page 87.

SYSTEM This is a function for automatically turning off the

OFF power of devices connected to the receiver. Multiple remote control codes can be set, as desired. See “Multi Operation and System Off” on page 87.

DIRECT This is a setting for changing only the remote

FUNC control unit’s operation screen, without changing the receiver’s input, when the remote control unit’s input function buttons are pressed. This is convenient for using the remote control unit for devices not connected to the receiver. See “Direct function” on page 86.

RENAME The names of the input function buttons displayed on the remote control unit can be changed as desired. See “Renaming input function names manually” on page 86.

Setting	What it does
SYNC	Input function names changed on the receiver can

RENAMING be acquired by the remote control unit so that the names are the same on the remote control unit. See “Renaming input function names in synchrony with the receiver” on page 93.

ERASE	This function is used to erase remote control
LEARNING	codes that have been learned. Codes learned for
	the different input functions can be erased
	individually. See “Erasing one of the remote
	control button settings” on page 85.
IR/RF	This function is for selecting wireless (RF) or
SELECT	infrared (IR) as the remote control operating mode
	for the different devices. See Operating this receiver
	by RF communications and Operating other
	components by RF communications on page 92
OPERATION The remote control unit’s operation screen
MODE	switches automatically when the receiver’s input
	is switched (This is only valid when the operation
	selector switch is set to SOURCE). See “Setting the
	remote control operation mode” on page 94.
KEY RESET	This is a function for resetting preset codes that
	have been set. Key resetting can be done for
	individual input functions. See “Resetting the
	input assignment of one of the input function
	buttons” on page 86.
ALL RESET	This is a function for resetting all remote control
	unit settings you have made to the defaults set
	upon shipment from the factory. See “Resetting
	the remote control settings” on page 86.
READ	The preset codes set for the different input
PRESET ID	functions can be checked. See “Confirming preset
	codes” on page 86.
CHANGE	If you have multiple Pioneer receivers, amplifiers,
RC MODE	etc., this setting can be used to prevent other units
	from operating simultaneously when the remote
	control unit is operated. See “Operating multiple
	receivers” on page 84.
EXIT	Exits the setup menu.
SETUP

Note

•You can cancel or exit any of the steps by press and hold MULTI OPERATION for a couple of seconds. To go back a step, press RETURN.

•After one minute of inactivity, the remote automatically exits the operation.

83

En