Rear Panel
Image Select switch
Changing the switch setting flips the image vertically. Set this switch as required by unit installation.
Expansion terminal(RGB)
Video input
Remote control connector Connect the supplied remote control sensor to this connector.
Power connector
Connect the supplied power cable to this connector.
English
Owner’s
Manual
Image Select Switch Setting
Observe the following instruction in installing the unit.
Note:
The unit must be installed horizontally.
●Console box installation | ●Ceiling installation |
| Installation surface |
Installation surface
Set the Image Select switch to position “UP”.
Set the Image Select switch to position “DOWN”.
VMA7483 9