Installation

The HRB100 mounting adapter allows secure

installation of the Directed Video RVM Series

Removable Monitors by installing the mounting

assembly into the vehicle headrest or seatbacks.

The HRB100 will accommodate the Directed Video

5.6”, 6.8”, and 7.0” monitors.

The HRB100 consists of two major pieces: the

receiver bracket and the headrest bucket.

1.Using the supplied template, center the cut out area on the headrest or seatback and mark the fabric area to be cut as indi- cated. With a new razor knife, cut the fab- ric as marked. Then cut the foam as indi- cated on the template. Using the knife remove as much of the foam padding as necessary to allow clearance of the moni- tor bucket.

WARNING! Be careful not to remove the headrest fab ric past the line marked FABRIC CUT LINE. If the fabric is removed past this line, the headrest’s inner foam may be visible after the completed installation.

2.Once the headrest has been marked and cut to accommodate the monitor bucket the metal support bar around the inside of the headrest will be noticeable. The mon- itor bucket will be secured to this bar.

3.Run the supplied din cable through the bottom of the headrest. Leave enough slack in the cable so the headrest still has full movement during adjustment.

4.Secure the headrest bucket by tying the supplied zip ties through the mounting feet and around the metal support bars.

5.The RVM Monitor locks into the receiver bracket until physically released. The release mechanism is in the rear of the bracket.

8	© 2003 Directed Electronics, Inc.