Installation Using Half-Sleeve

1Install half-sleeve in the dashboard.

a.Install adapter if necessary (optional).

b.Install half-sleeve into adapter or dashboard (use only the supplied screws). Do not force the sleeve into the opening or cause it to bend or bow.

WARNING! Only connect the unit to a 12-volt power supply with proper grounding.

c.Locate the series of bend-tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary so that the sleeve is ﬁrmly secured to the dashboard.

2Use the M5 x 6 screws (provided) to install the mounting brackets to each side of the radio using the holes indicated

in the diagram. DO NOT USE OTHER SCREWS.

3Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve.

4Complete wiring as illustrated in the wiring diagram. Once the wiring is complete, reconnect the battery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.

CAUTION! Be careful not to damage the car wiring.

5After completing the wiring connections, turn the unit on

to conﬁrm operation (ignition switch must be on). If unit does not operate, recheck all wiring until problem is corrected. Once proper operation is achieved, turn off the ignition switch and proceed with ﬁnal mounting of the chassis.

a.Connect wiring adapter to existing wiring harness.

b.Connect antenna lead.

c.Carefully slide the radio into the half-sleeve, making sure it is right-side-up. Use the supplied screws to at- tach the radio to the half sleeve.

Using the Cosmetic Trim Ring

Two cosmetic trim rings are packaged with the head unit for installation ﬂexibility. This unit will ﬁt into most import dashes with little or no modiﬁcation to the dash board/cavity. Some US domestic vehicle dashes will accept a Double-DIN chassis, but there is usually a small gap between the radio and dash piece af- ter installation is complete. In this case, use the appropriate trim ring to conceal any gaps that may be present.

NOTE: For proper operation of the CD/DVD player, the chassis must be mounted within 30° of horizontal. Make sure the unit is mounted within this limitation.

Step 1-b

Step 1-c

TAB

DASHBOARD

Step 2

Step 5-c

TRIM RING

MOUNTING

SLEEVE