Introduction and System Overview
Introduction and System Overview
Congratulations on your purchase of a Rosen Widescreen Universal Monitor! This widescreen flat panel LCD monitor features advanced display technology and versatile installation options.
Your Rosen Widescreen Universal Monitor includes the following features:
•16:9 aspect ratio. Sometimes called “widescreen,” this is the same aspect ratio used by next generation digital televisions.
•7" screen (measured diagonally).
•Adjustable backlight to compensate for ambient lighting conditions.
•Normal, Zoom, and Full screen formats.
•Front panel and remote controls. These controls allow adjustment of the video settings, control of the backlighting, format, and video source. (For more information, see “ Remote Control” on page 4).
•RCA video inputs.
•RCA auxiliary video output.
Important Notices
•NEVER install this monitor where it can be viewed from the driving position; this is a violation of many state and local vehicle codes.
•Use this monitor only after proper installation by a qualified installer.
•Avoid mounting locations where there is a risk of impact with a passenger in the event of an accident.
•Always mount the monitor securely using the mounting hardware that is provided. Do not use the monitor unless it is properly secured to the vehicle.
•Avoid touching the LCD screen except when cleaning it with a soft dry cloth.
Installation
Physical Mounting
Two mounting options are available - pedestal mounting or flush mounting.
Pedestal Mounting
To install the pedestal mount:
1.Select appropriate locations in your vehicle for the pedestal and for the power supply module.
2.Test fit the mounting pedestal foot in the desired location:
•Be sure that the monitor will be able to slide onto the pedestal without interference.
•Be sure that the mounting location can accommodate screws safely. Never screw into any surface without first inspecting behind and below it.
3.Ensure that the interconnect cable will reach from the monitor location to the power supply module location.
4.If the mounting surface is not perfectly flat, bend the flanges on the mounting foot for the best fit without yet removing the backing from the flange’s
5.Remove the tape backing and press the pedestal into place.
6.Screw the pedestal into place with the mounting screws provided.
7.Slide the monitor onto the pedestal as shown, and tighten the adjustment knob. Adjust viewing angle as needed.
UN7000 7” Widescreen Universal Monitor | Page 4 | UN7000 7” Widescreen Universal Monitor | Page 13 |