ClearVUe Ultra_final.fm Page 1 Sunday, February 10, 2002 7:10 PM
ClearVue Ultra Owner’s Manual
INTRODUCTION
The Rosen ClearVue Ultra system installed in your vehicle has been chosen to give the occupants a more enjoyable journey.
Ensure that you and your passengers take time to read these instructions.
DISPLAY
Unlike conventional TV screens, the Ultra system monitors are Liquid Crystal Display (LCD) panels allowing for a compact, lightweight design. Because of this, the following should be observed:
•Do not press on the monitor unit; this can distort the picture or damage the LCD panel.
Portable radios and telephones
When using portable radios and telephones near the unit, picture or sound interference may occur. Do not use these devices near this unit.
SWITCHING ON
Use the Ultra system when your vehicle is running or the ignition switch is in the “accessory” position.
Note: It is not advisable to use the Ultra system for long periods without the engine running in order to avoid a dead battery.
IMPORTANT
•If temperature limits are exceeded, the Ultra system automatically shuts down and ejects the disc. When the temperature inside the vehicle returns to normal, power on the Ultra system by pressing POWER on the remote control or opening and closing the monitor.
•Clean the LCD panel with a slightly damp, soft cloth using a mild household detergent.
•Do not use solvents such as benzene, thinner, commercially availa- ble cleaners or antistatic spray.
•Do not use this unit in temperatures under 0°C (32°F) or over 80°C (176°F).
•If your car was parked in a cold or hot place, the picture may not be clear. The monitor is not damaged.
The picture will become clear after the temperature in your car returns to normal.
1