StartYour Installation

uConnecting the Display (Figure 9.1)

To setup this display, please refer to the following figure and procedures.

1.Be sure all equipment are off.

2.Connect the DC power cord to the power connector (The arrow sign must face down); plug one end of the AC power cord into the power adapter, and then the other end into an electrical outlet(Œ).

3.For the PC with Analog output: Connect the VGA signal cable from display VGA input connector to the 15-pin connector of your host com puter and tighten the screws(•).

4.Connect the Audio-In cable from audio input port of your display to the Audio-out port of your computer(Ž).

5.Connect your headphone to Headphone port(•).

6.Connect the USB cable from USB input port of your display to the USB port of your computer(•).

7.Turn on your computer, display and video source.

Notice: To ensure the LCD display can work well with your computer, please configure the display mode of your graphic card to make it less than or equal to 1280 x 1024 resolution and make sure timing of the display mode is compatible with the LCD display. We have listed the “Compatibility Modes” of this LCD display in appendices for your reference.