Wall-mount instruction
Preparing To Install The Optional Wall Mount Arm (not included) This TFT LCD Monitor can be attached to a wall mounting
arm you can purchase separately.1 Turn the power OFF then disconnect the cables from the 
TFT LCD Monitor before performing the procedure below.
1.Lay the TFT LCD Monitor face down on a soft surface.
2.Remove the 4 screws holding the stand to the hinge.
3.Remove the stand.
Attaching The Optional Wall Mount Arm (not supplied) Follow these steps to finish installing the wall mounting arm:
1.Place the wall mounting arm onto the back of the TFT LCD Monitor. Line up the holes of the arm with the holes in the back of the monitor.
2.Insert the 4 screws into the holes and tighten.
3.Reconnect the cables. Refer to the User’s Guide that came with the optional wall mounting arm for instructions on attaching it to the wall.
NOTE
●100 mm x 100 mm VESA high hole (n=4), M4, pitch =0.7 mm screw mounting kit not included.
2
3
100mm x 100mm Screw Mounting Options
100mm 
100mm
4mm, 0.7 pitch threaded holes x 4
14