Planar PX2211 MW manual Error Message & Possible Solution No Signal, Input not Support

Page 22

ERROR MESSAGE & POSSIBLE SOLUTION

NO SIGNAL :

1.Check that the signal-cable is properly connected , If the connector is loose, tighten the connector’s screws.

2.Check the signal-cable’s connection pins for damage.

INPUT NOT SUPPORT :

Your computer has been set to unsuitable display mode ,set the computer to display mode given in the following table.

20

Image 22

Contents Page Page Page Page Page Table of Contents For Your Safety FCC Class B Radio Frequency Interference StatementPrecautions Checking the Contents of the Package FeaturesSpecial Notes on LCD Monitors Installation Installation Instructions BaseRemove Controls and Connectors Signal Cable Adjusting the Viewing Angle General Instructions External ControlsFront Panel Control MENU/ENTERHOW to Adjust a Setting Press the MENU-button to activate the OSD windowAdjusting the Picture Main Menu Icon Sub Description Main Menu Icon Sub Description Main Menu Icon Sub Description Plug & Play DDC 2B Feature Plug and PlayTechnical Support FAQ Error Message & Possible Solution No Signal Input not SupportSpecifications AppendixFactory Preset Timing Table Standard ResolutionConnector PIN Assignment Description PIN noPin Signal Name Pin No Register Your Planar Products Today Cables, Replacement Lamps, Accessories Technical SupportPlanar Support Page Page Page Page Q41G22M1935 1A