Planar PCT2265 manual Adjusting the Viewing Angle

Page 11

ADJUSTING THE VIEWING ANGLE

For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your own preference.

Hold the stand so you do not topple the monitor when you change the monitor’s angle.

You are able to adjust the monitor’s angle from -5° to 90°.

Figure 3

NOTES

Do not touch the screen when you change the angle. It may cause damage or break the screen.

Careful attention is required not to catch your fingers or hands when you change the angle.

10

Image 11
Contents PCT2265 Page Table of Contents FCC Class B Radio Frequency Interference Statement For Your SafetyPrecautions Page Before YOU Operate the Monitor Package List 122mm Adjusting the HeightUSB Cable a to B Controls and Connectors Power CordSignal Cable Adjusting the Viewing Angle Down Auto General InstructionsMenu / Enter Front Panel ControlOSD Message HOW to Adjust a SettingDCR Adjusting the PictureDDC/CI OSDPlug and Play Plug & Play DDC2B FeatureUsing the Right Power Cord CALIBRATION/RESET Instructions Problem & Question Possible Solution Technical Support FAQInput not Support Technical Support FAQError Message & Possible Solution No Signal TTL SpecificationsHdmi DVI-DStand Resolution Horizontal Factory Preset Timing TablePIN no Description Connector PIN AssignmentDDC CLK CECDDC SCL Wall Mounting Optional Planar Support Cables and Accessories Technical SupportPN 020-1236-00B
Related manuals
Manual 27 pages 42.68 Kb