CONTROLS AND CONNECTORS
POWER CORD
Power Source:
1.Make sure that the power cord is the correct type required in your area.
2.This monitor has an internal universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.)
3.Connect the
SIGNAL CABLE
Connecting the Signal Cable : Plug one end of the signal cable to the LCD monitor and the other end to a computer or a video source.
USB Cable – A to B
The USB Cable – A to B – must be connected from the monitor to the computer for the touch screen to operate.
Connecting the USB Cable: Plug one end of the cable to the monitor – USB Cable (upstream) slot - and the other end to a USB port on the computer. Refer to page 17 for Calibration and Reset Instructions.
Caution: If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied).
8
1
2 3 4 | 5 6 878 |
|
| Figure 2 | Connecting Cables | ||
|
|
|
|
|
|
1. | Power Cable |
| 5. |
| Audio cable |
2. | HDMI Cable |
| 6. |
| USB Cable*2 (downstream) |
3. | DVI Cable |
| 7. |
| USB Cable (upstream) |
4. |
| 8. |
| USB Cable*2(downstream) |
9