Troubleshooting, Symptom How To Check

Troubleshooting

Symptom		How To Check
	• Make sure the AV IN/OUT switch on the right side of
		the player unit is in the OUT position for standard
		play.
	• Make sure the disc cover is completely closed.
	• Make sure a disc is loaded.
The player cannot play.	• Make sure the disc is loaded with label side up.
The player cannot play.	• Disc should be clean, not dirty or warped.
	• Disc should be clean, not dirty or warped.
	• Player’s region code should be the same as the
		region code of the DVD disc.
	• Make sure water condensation has not occurred? If
		it has, remove the disc and keep the player power
		on until the moisture evaporates.
	• Make sure the system connection is correct.
There is no sound.	• Make sure the sound setup of DVD disc is correct.
There is no sound.	• Is your disc dirty or warped? Clean or replace it.
	• Is your disc dirty or warped? Clean or replace it.
	• If wired headphones are plugged in, unplug them.

	• Make sure DVD Player is turned on and in correct
There is no picture.		video mode.
	• Make sure your system connection is correct.
Poor AV performance.	•	Is your disc dirty or warped? Clean or replace it.
Cannot continue to play and	• Make sure the player is not in A-B repeat status.
Cannot continue to play and	• Press A-B button to cancel A-B repeat status.
play a section repeatedly.	• Press A-B button to cancel A-B repeat status.
play a section repeatedly.	• Is your disc dirty or warped? Clean or replace it.
	• Is your disc dirty or warped? Clean or replace it.

	• Make sure there is no obstruction between the
		remote control and the player.
The remote control does not	• Make sure you are pointing the remote control
The remote control does not		towards the player.
work.		towards the player.
work.	• Make sure battery is inserted correctly (check
	• Make sure battery is inserted correctly (check
		polarity).
	•	Replace weak battery.

WARNING: Do not touch any metal objects to the Battery connectors, as it will put the Battery in standby mode. To exit the standby mode, connect the Battery and DVD Player to AC or DC power.

Other possibilities:

Static or other external interference may cause the player to function abnormally. Unplug the power-supply cord from the outlet and plug it in again to reset the player so that normal operation can resume. If you are still having problems, then disconnect the power to the DVD Player and consult a qualified technician.

- 28 -