III. Installation of Console

4.Install mounting bracket (item 6 pg 2) and secure using

(2)two # 10 x 3/4" screws (item 1 pg 2) in bottom flange that aligns with dimples in roof brace. Secure top flanges using (2) two # 8 x 3/4" screws (item 3 pg 2). See Figure 4.

FIGURE 4

NOTE: Additional assistance in mounting the overhead console in vehicle is advised to prevent damage to console or components.

5.Install and route all accessory wiring, video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar. Down the B-pillar to the floor. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 5. Connect per instructions included with video system. If video system is to be used as a television, install an appropriate antenna per instructions included with antenna.

FIGURE 5