attach the "S" connector to the rail directly, as it may not be long enough to reach back to the ring.
3)Adjust the straps tightly so that the bag is secured.
4)Unzip the bag and flip down the front flap. Ensure the inside Velcro strap of the bag is fastened to prevent the unit from fall- ing. Swing the monitor upwards and adjust the screen for the desired viewing angle.
3.Installing the system on the back seat in a car (Refer to Figure 9)
There is no need to remove the four straps from the bag as they are not used in this installation.
Figure 9
Ensure the rear piece of the bag is attached to the upper Velcro strap on the back of the bag. Carefully place the system (front fac- ing up) on the back seat. Guide the vehicle’s safety belt through the rear piece of the bag. Then secure and adjust the safety belt so that the system is not free to move around. Finally uncover the bag, swing the monitor upward and adjust the screen for the de- sired viewing angle. Ensure the inside Velcro strap of the bag is fastened to prevent the unit from falling.
10