To Use Repeat Feature:
1.While a disc is playing, press Repeat button or right arrow button (u) on the remote to bring up the Repeat icon.
2.Press the up/down arrow buttons (▼▲ ) to highlight the Repeat option (Repeat Off, Repeat One, Repeat Disk, Repeat Dir).
3.Press ENTER on the remote. The selected repeat option will shown on the right side of Time Display.
Troubleshooting
PROBLEM | SOLUTION | |
|
| |
Poor in vehicle | • Check the condition of the vehicle’s | |
radio reception | radio antenna. | |
(FM modulator | • Verify that the antenna is fully raised. | |
installed) | • If a wired RF modulator has been | |
| installed, verify that it is turned OFF | |
| by using remote. | |
|
| |
IR sensor | • Verify that the batteries in the remote | |
inoperative | are fresh. | |
| • Verify that the remote sensor eye is | |
| not obstructed. | |
| • Verify that the infrared transmitter is | |
| affixed over the sensor eye of the | |
| component to be controlled. | |
|
| |
Disc won’t play | • Insert a disc with the label side facing | |
up. | ||
| ||
| • Check the type of disc you put into | |
| disc tray. This DVD only plays digital | |
| video discs, audio CDs and MP3s. | |
| • Both the unit and the disc are coded | |
| by region. If the regional codes don’t | |
| match, the disc can’t be played. This | |
| DVD is Region Number 1. | |
|
| |
Play starts, but | • The disc is dirty. Clean it. | |
then stops | • Condensation has formed. Allow | |
immediately | player to dry out. | |
|
|