Wired FM Modulator
Your video system may be equipped with an RF modulator, that allows you to listen to the VOH682’s audio signal by tuning your vehicle’s radio to the selected frequency, (88.7 or 89.1 - Check with your installer) and turning on the remote mounted RF modulator switch. (In most cases this toggle switch will be located underneath the driver’s side of the dash, check with your installer for the exact location.) Whenever the RF modulator is on, broadcast radio reception will be poor. Turning the remote mounted toggle switch off will allow normal radio reception.
Video Output
The VOH682 provides a video output for an optional video monitor(s). (Refer to page 7 of the installation guide for more details.) This output will provide a video signal that duplicates the signal displayed by the VOH682 to an additional monitor or video display. Please see your installer for more information.
Audiovox Video Cassette Player (Aux Video 1) In most installations a VCP will be connected to the “Video 1” input. To view a video cassette, turn the VOH682 On and press the source button on its control panel or the TV / Video button on the remote control until “Video 1” is displayed on the screen. The VCP may also be operated with the remote or the buttons on its face. The VOH682 is now ready to play the audio and video signals from the VCP if it is connected to the “Video 1” input. Inserting a tape into the VCP will turn it on and automatically activate the play mode. If a rewound tape had already been loaded into the VCP, prior to its activation press play on the VCP or on the remote control to view the tape. For more information see the operator’s manual accompanying your VCP.