CHANNEL TUNING SET UP
In order to easily access all available TV channels, it may be necessary to perform channel auto- programming whenever the vehicle’s geographic location has changed, i.e. city to city, weak signal area.
1.Press the AUTO MEMORY button on the Remote Control Unit or the AUTO PROGRAM button on the drop down video unit. You will see the TV cycle through all its channels. The
2.(A) To tune only strong clear channels with the CHANNEL UP/DOWN buttons, press the SKIP/ SEARCH button on the Remote Control Unit until “SKIP MODE ON” is displayed on the bottom of the screen. The TV will now tune only to strong active channels when the UP or DOWN buttons are used on the monitor or remote control.
(B) To tune weak or marginal channels with the CHANNEL UP/DOWN buttons , press the SKIP/ SEARCH button on the Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of the screen. Tune to the desired channel using the CHANNEL UP/DOWN buttons or go directly to the channel by using the
4.To ERASE a channel, press the ERASE/WRITE button on the Remote Control Unit until “MANUAL MEMORY XX ERASE” is displayed on screen. To STORE a channel, press the button until the MANUAL MEMORY XX ADD is displayed on screen.
Note: Please refer to page 2 for more information on TV reception.
Turning the VOH682 On or Off
1Sliding the screen release lock forward will unlock the LCD screen and it will drop down slightly. Pivot the screen downward until a comfortable viewing angle is reached. The internal friction detent will hold the screen in position while the system is in use.
2Pressing the power button on the pod or the remote will turn the system on or off alternately. When in use the internal backlighting will illuminate the controls.
3After the unit has been turned on and is displaying a picture, adjust the viewing angle, by pivoting the screen to optimize the picture quality.
4Remember to turn the unit off and pivot the LCD to the locked position when not in use.