Audiovox VOH1502 manual Remote Control Operation, TV Power

REMOTE CONTROL OPERATION

(See Figure 3)

Monitor Controls:

1.TV POWER

Press this button to turn on the VOH1502. Press the button again to turn the set off.

2.Direct Access (0-9,1--) Number Buttons Use these buttons to select a channel. The channel number chosen will be displayed on the screen for about four seconds. To select channels 0-99, press two number buttons. For example, to select channel 8, press 0,8. To select channels above 100, press the 1—button, then the number buttons for the last two digits of the channel. For example, to select channel 115, press 1--, 1, 5.

3.CHANNEL p/q Buttons

Use these buttons to advance to the next higher (p) or lower (q) channel. (Also used to scroll Up/Down through the menu options).

4.VOLUME + / – Buttons

Use these buttons to raise or lower the volume level of the Wired Headphones or External Speakers if installed. They are also used to make adjustments in the picture select mode.

NOTE: These buttons will not affect the volume of wireless headphones or a wired RF modulator. When using these devices the volume must be adjusted with the headphone volume control or with your radio’s volume control.

5.MENU Button

Press the MENU button. The MENU display appears. Use the channel p and q buttons to highlight the desired function, then press the ENTER button to confirm your selection.

6.TV/VIDEO Button

Press this button to access the AUDIO/VIDEO inputs. As the button is pressed, the on screen display will cycle as follows:

TV AV 1 AV 2 AUX

7.MUTE Button

Press this button to turn the TV sound off. Press the button again to restore the sound to the previously set level. MUTE may also be released by pressing the VOLUME +/–.

8.ERASE/ADD Button

When tuned to a channel press this button to store or erase the channel from memory.

6