4.To ERASE a channel, press the ERASE/WRITE button on the Remote Control Unit until “MANUAL MEMORY XX ERASE” is displayed on screen. To STORE a channel, press the button until the
MANUAL MEMORY XX ADD is displayed on screen.
Note: Please refer to page 2 for more information on TV reception.
FM Radio Operation
1.If using wired headphones, insert the headphone set plug into the headphone jack on the right side of the LCD pod labelled RADIO EAR. If using a switch the channel A/B switch to channel B for the FM radio. Channel A is used for video audio.
2.Press the Radio power on button. The LCD window will display the FM station frequency and memory channel number.
3.Press the tuning UP or DOWN button to select the desired radio station.
4.If the radio station is broadcasting in stereo, then LCD window will display STEREO.
5.Press the Memory button and select the preset number you wish to assign. The number can be selected from 1 to 6 sequentially. The selected number will flash. Press and hold the memory button until the display stops flashing. The preset will be stored after 2 seconds. The number will
then be displayed continuously. The number will be displayed continuously. The desired frequency is now. The unit can store 6 radio station frequencies using the above procedure.
6.Pressing the Recall button will scroll through the six presets.
7.Pressing the Volume UP or DOWN button in the remote control unit will set the desired volume level in the headphones.
8.Press the Mute button on the remote control unit to mute the sound in headphone and press Mute button again to restore the sound to the original level.
Turning the VOH684 On or Off
1.Sliding the screen release lock forward will unlock the LCD screen and it will drop down slightly. Pivot the screen downward until a comfortable viewing angle is reached. The internal friction will hold the screen in position while the system is in use.
2.Pressing the power button on the pod or the remote will turn the system on or off alternately. When in use the internal backlighting will illuminate the controls.
3.After the unit has been turned on and is displaying a picture, adjust the viewing angle, by pivoting the screen to optimize the picture quality.
4.Remember to turn the unit off and pivot the LCD to the locked position when not in use.
128-6116
10 of 16