Battery Installation (Fig.2)
1.Place two alkaline AAA batteries in the Headphone’s battery compartment making sure that the battery polarity is correct.
2.Replace the battery cover.
Fig. 2
HEADPHONE OPERATION
IMPORTANT: To prevent possible ear damage, Read the following Carefully!
1.Turn the headphone volume down before turning on the power. Turn on the headphone power then increase the headphone volume to a comfortable level.
2.Before switching between channels A and B, remove headphones and turn the volume down because the signal of channel could be louder than the other.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Product Specifications:
Operating range : up to 25 Ft.
Frequency Response : 35 – 18,000Hz
S/N ratio : 60 dB
Channel Separation : 45 dB
Optional Accessories
Wired Headphone
There are two 1/8” headphone jacks on the VOH684 that can be used with any standard stereo headphones. The jack, TV EAR, is used to listen to the video program audio. The audio volume is controlled by the TV VOLUME up/down buttons. The jack, RADIO EAR, is used to listen to the FM broadcast. The audio volume is controlled by the RADIO VOLUME up/down buttons. Remove the protective plastic cover to access the jacks. Remember to replace the cover when the jacks are not in use.
128-6116
13 of 16