Audiovox VOH1332 installation manual Cut-Away View of Mounting Bosses, Antenna Information

Page 10

Cut-Away View of Mounting Bosses

Roof Structure

Screw Boss

C3

Note: If longer screws are substituted, care should be taken to prevent piercing the roof, and be sure that pan head screws and washers are used to prevent screws from pulling through the screw boss. Eight screws must be used and secured to solid structure when mounting.

Antenna Information

The following are a few points to consider in regards to TV reception in a mobile application.

Generally in a mobile application, the lower channels are the most difficult to receive due to the size of the antenna needed to receive the signal.

When the antennas are inside the vehicle, the TV signal can be obstructed by the outside metal of the vehicle. This will diminish UHF performance and may eliminate VHF reception altogether. VHF channels are 2-13 and UHF channels are 14-69.

Depending on the location of the antenna and the direction of the vehicle, some VHF signal may be received.

10

Image 10
Contents VOH1332 Package Contents FeaturesTools Required Rear Panel Feature Front Button Panel Features General Installation Approach Vehicle Preparation Wiring Diagram Hook Up Procedure Source Component Harness Hook Up Remote Control Functionality Television ControlsCut-Away View of Mounting Bosses Antenna InformationTroubleshooting Symptom Cause Possible SolutionSpecifications 1281332 Rev. B Oct